CRT Handbook · · 10 min read
CRT Stop Loss and Take Profit: Placing Both From the Range
A CRT Handbook lesson on stops and targets: where the stop goes for each entry, TP1 at the 50%, TP2 at the far side of Candle 1, and when to skip a trade.
Ask ten traders where their stop goes and you'll get ten answers: "20 pips," "below the last candle," "wherever the lot size works." That's not a strategy. That's hope with a number attached.
The direct answer for Candle Range Theory: the stop goes beyond the extreme Candle 2 made when it purged the range, plus a small buffer for spread. The first target is the 50% of Candle 1. The final target is the opposite side of Candle 1. All three prices exist before you enter. If the first target isn't at least twice your risk away, there's no trade.
That's Chapter 4 of the CRT Handbook, Stop-Loss & Target Placement. The chapter before it covers where to get in. This lesson covers the two prices that decide what that entry is worth.
The stop is where the idea dies
A stop isn't a distance you're comfortable with. It's the price at which your reason for the trade stops being true.
In CRT, Candle 1 set a range, Candle 2 ran one side of it into a past key level, and a turtle soup printed inside Candle 2. The thesis: price went there, found nothing, and came back. The wick Candle 2 left behind is the record of that failed run.
So if price trades back through that extreme, the run didn't fail. It's still running, and you're on the wrong side. That's why the stop belongs beyond the purge extreme, not at a round number, and not at "a bit more room than last time."
Position size comes after the stop, never before; the formula is in the risk management guide. This lesson is about where the stop goes, because the formula is useless if the input is random.
Three entries, three stop placements
Where the stop sits depends on which entry you took. Here's how I handle the ones from Chapter 3.
1. Early entry at the purge: stop beyond the extreme
If you're in on the purge order block, right after the turtle soup, you're as close to the invalidation as the chart allows. The stop goes just beyond the high (for a short) or the low (for a long) of the purge, with a buffer for spread.
This is where the extreme R multiples come from. In my 1:188 MNQ trade at the Sunday Asia open, the stop was 1.25 points, five ticks above the purge high. That stop was only valid because the 30-minute turtle soup defined a precise level where the trade stopped making sense. It also means a single tick of noise or slippage can take you out. Tight is not the same as safe.
2. Later entry on an IFVG, BPR or CISD: same stop, smaller R
If you missed the purge and enter on the IFVG retest or the CISD, the invalidation hasn't moved. The idea still dies beyond the purge extreme. So the stop stays there, and it's wider than it would have been on the early entry.
This is where traders cheat. They enter late, then tuck the stop just above the IFVG so the R:R still looks pretty. Now the stop sits inside the manipulation, and normal movement around the gap knocks them out of a trade that was still valid. If the later entry doesn't pay enough with the real stop, skip it. Don't invent a new invalidation.
3. O.T.E. entry: stop beyond the swing origin
Optimal Trade Entry has its own rule. It arms only after a market structure shift and a displacement leg with an FVG in it, and the zone is the 61.8%–79% retracement of that leg. The swing origin of the move is the invalidation. That's the stop.
The Structure Fib in the CRT Suite works the same way: it locks the range with 1 at the sweep (the stop) and 0 at the top of the move (the target), with the limit entry at 0.75 by default. Different tool, same principle. The stop sits where the structure you're trading stops existing.
The buffer: how much is "beyond"?
"Beyond the extreme" doesn't mean exactly on it. Your stop needs to clear the spread and the normal tick-by-tick jitter around that price.
- Forex: add at least the typical spread for the session. Spreads widen at the Asia open and around news, and a stop sitting exactly on the wick can be hit by the spread alone.
- Index futures: think in ticks. A couple of ticks beyond the extreme is enough on a calm open. Around high-impact news, the manipulation leg is often bigger and can overshoot levels it would normally respect, so either stay out or accept a wider stop and size down for it.
Keep the buffer small and the same every time. Adding "a little extra" because the trade feels shaky isn't a buffer. It's doubt.
TP1: the 50% of Candle 1
The midpoint of Candle 1 is equilibrium. Price is drawn to it, and it's very often the first place price reacts after a sweep. That makes it the natural first target.
I use it for two jobs:
- The go/no-go check. Before entry, measure from your entry to the 50%. If that distance isn't at least twice your stop, the trade doesn't make the cut. The reward is too small for the risk, no matter how clean the setup looks.
- The management point. The 50% is where I decide what to do with the rest of the position. More on that below.
TP2: the far side of Candle 1
The final target is the opposite boundary of Candle 1. If Candle 2 purged the high, the target is the Candle 1 low. If it purged the low, the target is the Candle 1 high. That's where the resting liquidity on the other side of the range sits, and that's where Candle 3 tends to deliver price.
Once a candle on the CRT timeframe closes through that target, the setup is complete. On the CRT Radar, that close clears the setup from the chart. By hand, it means the same thing: the trade has delivered, and anything after that is a new idea that needs its own setup.
When the target sits beyond Candle 1
Sometimes the higher timeframe tells you price has further to go. In the 1:188 trade, the target wasn't a Candle 1 boundary at all. It was internal range liquidity: an H4 fair value gap below that price had left on the way up. External liquidity was taken above (the previous day's high), so the plan was to deliver back into internal liquidity below. The time theory guide covers that IRL to ERL idea in depth.
Two rules keep this honest:
- Decide it before entry. An extended target comes from the map you drew before the trade, like a draw on liquidity or a higher-timeframe FVG. The Draw Engine exists to mark exactly that. It doesn't come from watching a winning trade and feeling greedy.
- Never push the target out mid-trade. Moving a target further away after you're in is the twin of moving your stop further away. Both mean the plan you wrote down no longer applies, and you're now improvising with real money.
Do the math before you click
Here's an illustrative example with made-up numbers, not a trade of mine. It shows why the same setup can be a trade for one person and not for another.
EUR/USD, H4 Candle 1: high 1.0860, low 1.0800. The 50% is 1.0830. Candle 2 purges the low down to 1.0788 into a previous day's low, an M15 turtle soup prints, and price closes back inside the range.
| Early entry | Late entry | |
|---|---|---|
| Entry | 1.0798 (purge OB) | 1.0815 (CISD) |
| Stop | 1.0785 (13 pips) | 1.0785 (30 pips) |
| TP1: 50% at 1.0830 | 32 pips = 2.5R | 15 pips = 0.5R |
| TP2: far side at 1.0860 | 62 pips = 4.8R | 45 pips = 1.5R |
| Verdict | Valid | Skip |
Same range, same sweep, same stop. The entry price alone turns a 2.5R first target into half an R. The late trader isn't wrong about direction; they're wrong about price. And if the early entry hits the stop, it's still a loss. A good R:R just means the loss is small and planned.
Managing the trade between TP1 and TP2
There's no single right way to manage the space between the 50% and the far side, but there are two clean ones. Pick one, write it in your plan, and stop changing it trade by trade.
- Option A: all in, all out. Stop beyond the purge, target at the far side, nothing in between. Simple, and the full R is there when it works. The price is that you'll watch some trades tag the 50%, turn, and come back to your stop.
- Option B: partial and breakeven. Book part of the position at the 50% and move the stop to entry. You give up some of the full move, and in exchange a trade that tags equilibrium and reverses ends near breakeven instead of at a full loss.
What doesn't work is Option C: deciding in the moment. Closing early because a candle looked scary, moving to breakeven after two ticks, then watching price wick your entry and run to target without you. That's emotion with a mouse. If you want to move to breakeven, do it at a defined point, like the 50% or roughly 1R, not when you get nervous.
The mistakes I see most
- Choosing the lot size first. Then the stop goes wherever the size allows. Backwards. Stop first, size second.
- Tucking the stop inside the manipulation to make a late entry look better.
- Moving the stop further away when price gets close. A planned loss becomes an unplanned one.
- Trading a setup that already delivered. If the CRT-timeframe candle has already closed through the far side, the trade is history. The setup invalidation guide covers that and the other reasons to walk away.
The three-price checklist
Before every CRT trade, I want three prices written down:
- Stop: beyond the purge extreme (or the O.T.E. swing origin), plus a fixed buffer.
- TP1: the 50% of Candle 1, at least 2R from entry.
- TP2: the opposite side of Candle 1, or a higher-timeframe target I marked before the session.
Three prices, written before the click. Then the job is to let them work. Every trade I take, wins, losses and breakevens, goes on the results page, and plenty of them end at the stop. That's the point: the stop was the plan, not a surprise.
Rule the candle, rule the trade.
Go deeper
Chapter 4 of the CRT Handbook lays out stop and target placement in full, alongside the range, entry and killzone chapters it depends on. The Handbook is the method; it doesn't include indicator access. If you'd rather have the range, the purge and the opposite C1 target drawn for you, that's the CRT Radar, and its companion Structure Fib locks the stop, the limit and the target into one range.
New to the model? Start with what CRT is, then read the key levels guide for why equilibrium and range extremes matter so much.
FAQ
Where do you put the stop loss in a CRT trade?
Beyond the high or low that Candle 2 made when it purged the range, plus a small buffer for spread. For an O.T.E. entry, the stop goes beyond the swing origin of the displacement leg.
What is the take profit in Candle Range Theory?
The first target is the 50% of Candle 1. The final target is the opposite side of Candle 1. A higher-timeframe target beyond it is fine only if you marked it before entry.
Should I move my stop to breakeven at the 50%?
It's one of two clean approaches. Booking a partial at the 50% and moving to breakeven protects you if price reverses from equilibrium, but it gives up part of the full move. Choose one approach and apply it every time.
What if my entry is late and the R:R is poor?
Skip it. The stop stays beyond the purge no matter when you enter, so a late entry means a wider stop and a smaller reward. If the 50% isn't at least 2R away, there's no trade.